Installation guide

Memory Locations and Replacement Procedures
B-6 Mode Switch Bank Settings and Optional Installations
DRAM SIMM Replacement Procedure
Removing the DRAM SIMM
ToremovetheexistingDRAMSIMM,proceedasfollows:
1. LocatetheDRAMSIMMconnectoronthemainPCboard.ReferbacktoFigure B‐2.
2. PushtheconnectorarmsawayfromtheDRAMSIMM,asshowninFigure B‐6,enoughto
releasetheDRAMSIMMfromtheconnectorcontacts.
Figure B-6 Removing Existing DRAM SIMM
3. PulltheDRAM
SIMMstraightupandremoveitfromtheconnectorcontacts.
Installing the DRAM SIMM
ToinstallaDRAMSIMM,refertoFigure B‐7andproceedasfollows:
1. PushtheconnectorarmsawayfromtheDRAMSIMMenoughtoinserttheDRAMSIMMinto
theconnectorcontacts.
2. InserttheDRAMSIMMstraightdownbetweentheconnectorcontactsenoughforthetabson
theconnectorarmstoalign
withthetwoDRAMSIMMalignmentnotches.
3. PushtheDRAMSIMMdownintotheconnectorcontacts.Thenrotatethetwoconnectorarms
towardtheDRAMSIMMtolockitintoplace.
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.
1 Connector arms 2 DRAM SIMM 3 Connector contacts
Â
Á
À
À
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.