Installation guide

Unpacking the DFE-Platinum Module
3-2 Installation
Unpacking the DFE-Platinum Module
UnpacktheDFE‐Platinummoduleasfollows:
1. OpentheboxandremovethepackingmaterialprotectingtheDFE‐Platinummodule.
2. VerifythecontentsofthecartonaslistedinTable 3‐1.
3. Removethetapesealonthenon‐conductivebagtoremovetheDFEmodule.
4. PerformavisualinspectionoftheDFE‐
Platinummoduleforanysignsofphysicaldamage.
ContactEnterasys Networksifthereareanysignsofdamage.Referto“GettingHelp”on
page xiii fordetails.
Installing Optional Network Expansion Modules
APhillipsscrewdriverisneededtoinstallanoptionalNEMintothe2G4082‐25.
Atthetimeofthisprinting,onlythe7G‐6MGBIC‐ANEMisavailableforthe2G4082‐25.Referto
yourreleasenotesforthelatestavailableEthernetinterface modules.The7G‐6MGBIC‐Aprovides
sixGigabit
portslotsforoptionalMini‐GBICconnections.
InstallinganoptionalNEMinvolves
•removingthecoverplatefromtheDFE‐Platinummodule,
• attachingtheNEMtotheDFE‐Platinummodule,and
•ifrequired,installingMini‐GBICs.
Formoreinformation,refertotheQuickReferencethatwasshippedwithyourNEM,ortheMatrix
NetworkExpansion
ModuleHardwareInstallationGuidelocatedontheEnterasys Networkswebsite.
Installing Module into Matrix E7 or N7 Chassis
Toinstalla2G4082‐25intoaMatrix E7orMatrix N7 chassis,proceeddirectlyto“Preparation”on
page 3‐3tostarttheinstallationprocess.
Table 3-1 Contents of DFE-Platinum Module Carton
Item Quantity
DFE-Platinum Module (2G4082-25) 1
This Installation Guide 1
Customer Release Notes 1
Note: Install any optional equipment before installing the 2G4082-25 into a chassis.
Caution: Failure to observe static safety precautions could cause damage to the DFE module.
Follow static safety handling rules and wear the antistatic wrist strap.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the board or
components can cause damage.
Precaución: Si no toma las medidas de seguridad necesarias para evitar descargas de
electricidad estática, es posible que el módulo se dañe. Siga los consejos de seguridad para la
manipulación del producto y no olvide utilizar la pulsera antiestática.
No corte la bolsa antiestática para sacar el módulo. Tenga en cuenta que si algún objeto cortante
entra en contacto con la placa o con los componentes, éstos podrían dañarse.