Installation guide

Using LANVIEW
4-2 Troubleshooting
(Groups 1 through 4). Each time the GROUP SELECT button is pressed, the GROUP LED lights
up in sequence, indicating which group is selected. The receive and transmit activity for that group
of segments is then indicated by the RX and TX LEDs for each port.
Figure 4-1 LANVIEW LEDs
Table 4-1 describes the LED indications and provides recommended actions as appropriate.
1
MGMT LED
2
Group 1, Port 1 LEDs
NOTE: The terms used in Tabl e 4- 1 indicate the following:
Flashing indicates an LED is flashing randomly.
Blinking indicates an LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid indicates a steady LED light. No pulsing.
Alternating indicates an LED is flashing in a steady rate other than 50% on, 50% off.
1X
G
R
O
U
P
1
11X
7H4382-49
FAST ENET
RESET
COM
CPU
MGMT
GROUP
SELECT
GROUP
1
2
3
4
5
6
7
8
9
10
11
12
1
2
3
4
À
GROUP
GROUP
SELECT
RX TX
Á