Installation guide

Completing the Installation
3-34 Installation
3.9 COMPLETING THE INSTALLATION
Completing the DFE module installation depends on if the module is being installed in:
• a new DFE module system (refer to Section 3.9.1), or
• an established, operating DFE module system (refer to Section 3.9.2).
3.9.1 Completing the Installation of a New System
In a new system of DFE modules, one of the installed DFE modules will become the management
module on chassis power up, and all DFE modules will automatically be set to the factory default
values. A complete list of the factory default values are provided in Chapter 3 of the Enterasys
Matrix DFE-Platinum Series Configuration Guide.
After installing all DFE modules into the host chassis and making the connections to the network,
proceed to the following First-Time Log-In Using a Console Port Connection procedure to access
the module management startup screen from your PC, terminal, or modem connection.
Modem Port Adapter Wiring and Signal Diagram
RJ45 DB25
Pin Conductor Pin Signal
1 Blue 2 Transmit (TX)
2 Orange 8 Data Carrier Detect (DCD)
4 Red 3 Receive
5 Green 7 Ground (GRD)
6 Yellow 20 Data Terminal Ready (DTR)
8 Gray 22 Ring Indicator
RJ45 Connector (Female)
81
Pins
DB25 Connector (Male)
131
Pins
14 25