Installation guide
Connecting to COM Port for Local Management
Installation 3-31
When these parameters are set, the Local Management password screen will display. Refer to the
Enterasys Matrix DFE-Platinum Series Configuration Guide for further information.
Figure 3-18 Connecting a VT Series Terminal
3.8.4 Connecting to a Modem
To connect a modem to an Enterasys Networks DFE module COM port (Figure 3-19), use a UTP
cable with RJ45 connectors and an optional RJ45-to-DB25 male adapter, and proceed as follows:
1. Connect the RJ45 connector at one end of the cable to the COM port of the module.
2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB25 modem adapter .
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit
1
UTP cable with RJ45 connectors
3
RJ45-to-DB25 VT adapter
2
RJ45 COM port
4
VT series terminal
1X
G
R
O
U
P
1
11X
7H4382-49
FAST ENET
RESET
COM
CPU
MGMT
GROUP
SELECT
GROUP
1
2
3
4
5
6
7
8
9
10
11
12
1
2
3
4
 ÀÃ
Á