Installation guide

Installing an Optional Mini-GBIC

3-4 Installation

2. Remove the Mini-GBIC from the packaging.

3. If there is a protective dust cover (see 5 in Figure 3-1 or Figure 3-2) on the Mini-GBIC port, do

not remove it at this time.

Installation

To install a Mini-GBIC with an MT-RJ connection, refer to Figure 3-1, for an LC connection, refer

to Figure 3-2, or for an RJ45 connection, refer to Figure 3-3, and proceed as follows:

1. Hold the Mini-GBIC with its top side facing up and its 7-pin edge connector facing the port

slot .

2. Carefully align the Mini-GBIC with the port slot .

3. Push the Mini-GBIC into the port slot until the Mini-GBIC “clicks” and locks into place.

Figure 3-1 Mini-GBIC with MT-RJ Connector

Mini-GBIC (MGBIC-MT01)

Port slot

Mini-GBIC

, top side

Mini-GBIC, protective dust cover

7-Pin edge connector (insertion side)

Release tab