Installation guide

Unpacking the DFE Module
3-2 Installation
3.1 UNPACKING THE DFE MODULE
Unpack the DFE module as follows:
1. Open the box and remove the packing material protecting the DFE module.
2. Verify the contents of the carton as listed in Table 3-1.
3. Remove the tape seal on the non-conductive bag to remove the DFE module.
4. Perform a visual inspection of the DFE module for any signs of physical damage. Contact
Enterasys Networks if there are any signs of damage. Refer to “Getting Help” on page xxii for
details.
3.2 INSTALLING AN OPTIONAL NETWORK EXPANSION MODULE
Refer to your release notes or the Enterasys Networks web site for the latest available network
expansion modules (NEMs).
A Phillips screwdriver is required to install an optional NEM into the 7H4382-49 or 7H4383-49
DFE module.
Installing a NEM involves
• removing the coverplate from the DFE module (7H4382-49 or 7H4383-49),
• attaching the NEM to the DFE module, and
• installing the Mini-GBICs.
Refer to the installation instructions shipped with the NEM for details.
Table 3-1 Contents of DFE Module Carton
Item
Quantity
DFE module (7H4382-49, 7H4383-49, 7G4270-12, 7G4202-30, or 7H4203-72) 1
Installation Guide 1
Customer Release Notes 1
Note: Install any optional equipment before proceeding to Section 3.4 for an explanation
of the rules to install different series modules in a Matrix E7 chassis.