Installation guide

Memory Locations and Replacement Procedures

Mode Switch Bank Settings and Optional Installations B-13

Figure B-12 Removing the Existing DIMM

3. Rotate the DIMM upwards, then remove it from the connector fingers.

Installing the DIMM

To install a DIMM, refer to Figure B-13 and proceed as follows:

1. Insert the DIMM down between the connector fingers.

2. Pivot the DIMM downward so the tabs on the connector arms align with the two DIMM

alignment notches. With the two connector arms spread outward, push the DIMM down between

the connector arms. Then release the two connector arms to lock the DIMM into place.

Connector arms

DIMM

Connector fingers

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling

sensitive electronic equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las

precauciones de seguridad para evitar descargas de electricidad estática.