Installation guide

Memory Locations and Replacement Procedures

Mode Switch Bank Settings and Optional Installations B-9

Figure B-9 Installing the DRAM SIMM on 7H4382-49 or 7H4383-49

Removing the DRAM SIMM from 7G4270-12, 7G4202-30, or 7H4203-72

To remove the existing DRAM SIMM, proceed as follows:

1. Locate the DRAM SIMM connector on the main PC board. Refer back to Figure B-6.

2. Push the connector arms away from the DRAM SIMM, as shown in Figure B-10, enough to

release the DRAM SIMM from the connector contacts.

Connector arms

Connector fingers

DRAM SIMM memory module

DRAM SIMM alignment notches (2)

Caution: Observe all antistatic precautions when handling sensitive electronic

equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las

precauciones de seguridad para evitar descargas de electricidad estática.