Specifications

Reviewing and Selecting a Boot Firmware Image
Enterasys D-Series CLI Reference 2-31
2. Loadyourpreviousversionofcodeonthedevice,asdescribedin“DownloadingaFirmware
Image”(page 2‐28).
3. Setthisolderversionofcodetobethebootcode,asdescribedin“ReviewingandSelectinga
BootFirmwareImage”(page 2 ‐31).
4. Reloadthesavedconfigurationontothedeviceas
describedin“configure”(page 2‐39).
Reviewing and Selecting a Boot Firmware Image
Purpose
Todisplayandsettheimagefiletheswitchloadsatstartup.TheD2switchallowsyouto
downloadandstoreabackupimage,whichcanbeselectedasthestartupimagebyusingthe
commandsdescribedinthissection.
Commands
show boot system
Usethiscommandtodisplaythefirmwareimagetheswitchloadsatstartup.
Syntax
show boot system
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaytheswitch’sbootfirmwareimage:
D2(su)->show boot system
Current system image to boot: bootfile
For information about... Refer to page...
show boot system 2-31
set boot system 2-32