Specifications

show eapol
Enterasys D-Series CLI Reference 17-17
Thisexampleshowshowtoresetthe802.1Xquietperiodto60secondsonportsfe.1.1‐3:
D2(su)->clear dot1x auth-config quietperiod fe.1.1-3
show eapol
UsethiscommandtodisplayEAPOLstatusorsettingsforoneormoreports.
Syntax
show eapol [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,onlyEAPOLenablestatuswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayEAPOLstatusforportsfe.1.1‐3:
D2(su)->show eapol fe.1.1-3
EAPOL is disabled.
Port Authentication State Authentication Mode
-------- -------------------- --------------------
fe.1.1 Initialize Auto
fe.1.2 Initialize Auto
fe.1.3 Initialize Auto
Table 17‐43providesanexplanationofthecommandoutput.Fordetailsonusingtheseteapol
commandtoenabletheprotocolandassignanauthenticationmode,referto“seteapol”on
page 17‐19.
port‐string (Optional)DisplaysEAPOLstatusforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsed
intheCLI”onpage 6‐1.