Specifications

clear port mirroring
Enterasys D-Series CLI Reference 6-35
Usage
NotethatLAGportsandtheirunderlyingphysicalports,asdescribedin“LinkAggregation
ControlProtocol(LACP)”onpage6‐36,cannotbemirrored.
Example
Thisexampleshowshowtocreateandenableportmirroringwithfe.1.4asthesourceport,and
fe.1.11asthetargetport:
D2(su)->set port mirroring create fe.1.4 fe.1.11
D2(su)->set port mirroring enable fe.1.4 fe.1.11
clear port mirroring
Usethiscommandtoclearaportmirroringrelationship.
Syntax
clear port mirroring source destination
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearportmirroringbetweensourceportfe.1.4andtargetportfe.1.11:
D2(su)->clear port mirroring fe.1.4 fe.1.11
source Specifiesthesourceportofthemirroringconfigurationtobecleared.For
adetaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage6‐1.
destination Specifiesthetargetportofthemirroringconfigurationtobecleared.