User Guide

WAN Configuration
2-24 Local Management User’s Guide
Configuration: Frame Relay
This section provides step-by-step instructions for configuring the HSIM or CyberSWITCH to use
a T1 circuit in a Frame Relay environment. This example assumes the setup shown in Figure 2-12
using two CSX400s, each with an HSIM or CyberSWITCH installed. Configurations may vary
depending on the host platform.
Figure 2-12 Frame Relay Configuration
The line configuration information shown in Table 2-3 must be supplied by the service provider.
Table 2-3 Telco Configuration Information
Configuration Information
Required by Customer
Information Supplied by
Service Provider
Line Coding B8ZS or AMI
Frame Type ESF or D4
Clock Source Loop Timing or Local Timing
DS-0s (Timeslots)
Timeslots being used for each end of
the circuit
SITE #1
Telco Cloud
24 Timeslots
24 Timeslots
SITE #2
1482_05