User Guide

WAN Configuration
2-10 Local Management User’s Guide
WAN Interface Configuration Screen
This section describes the features of the WAN Interface Configuration screen. Access the screen
by using the arrow keys to highlight the WAN INT CONFIG command field at the bottom of the
WAN Physical Configuration screen, then press ENTER. The WAN Interface Configuration screen
displays, as shown in Figure 2-6.
Figure 2-6 WAN Interface Configuration Screen
WAN Interface Configuration Screen Fields
This section describes the WAN Interface Configuration screen fields.
Interface Number (Modifiable) Displays the active Interface Number. Use this field to
configure the Interface Numbers assigned on the WAN Physical Configuration screen.
Max Xmit Unit (Modifiable) User-configured field that displays the maximum packet size that
can be transmitted on the selected Interface. Defaults are 1506 for PPP and 4095 for Frame Relay.
The default settings for this field depend on the Protocol Manager chosen.
WAN INTERFACE CONFIGURATION
RETURN
SAVE
Interface Number: 000
Max Xmit Unit: 0
ProtMgr Iface: [0]
Active Protocol: FR
FR LMI: [ANSI_94]
DLCI Address: 0
DLCI DCP En:
DLCI DCP Stat:
Comp Ratio:
Circuit State: [Invalid]
2750_04
<host name> Local Management Flash Image Version: 02.xx.xx
001
002
003
004
005
006
007
008
009
010
011
012
013
014
015
CKT# IF# LID STATE
018
019
020
021
022
023
024
025
026
027
028
029
030
031
032
CKT# IF# LID STATE
016
017
001 Enet UP
PORTS:
[1-32 ]
002
Enet DOWN