User Guide

Local Management
1-46 Local Management User’s Guide
Figure 1-16 IP OSPF Configuration Screen
To enable OSPF complete the following steps:
1. From the Router Select screen, select IP and press ENTER. The IP Configuration screen
displays.
2. From the IP Configuration screen, use the arrow keys to select IP OSPF. Press ENTER, and
the IP OSPF Configuration screen shown in Figure 1-16, displays.
3. Use the arrow keys to select OSPF: Disabled. Press ENTER. The selection will toggle to
Enabled.
4. Use the arrow keys to select Area ID: 0.0.0.0. Enter the Area ID number in dotted decimal
format (000.000.000.000). When you have finished entering the area ID number, use the arrow
keys to select Admin Status:. If Admin Status is Disabled, press ENTER to toggle the status
to Enabled. Use the arrow keys to select Port:. Type the port number you wish to use. Press
ENTER, and the port will be changed to the number that you typed.
<host name> Local Management Flash Image Version: 02.XX.XX
IP Router ID: XXX.XXX.XXX.XXX
IP OSPF
OSPF: DISABLED
------OSPF Area Setup------
Area ID: 0.0.0.0 Import As Extern: true
------OSPF Port Level Setup-----
Admin Status: ENABLED Port: 1 IP Address: XXX.XXX.XXX.XXX
I/F Area ID: 0.0.0.0 Type: broadcast
Router Priority: 1 Transit Delay: 1 Poll Interval: 120
Retrans Interval: 5 Hello Interval: 10 Router Dead Intvl: 40
Auth Key Type: none
Active Auth Key: none Auth Key(2): none
Auth Key ID: Auth Key(2) ID:
State: down
Designated Rtr: 0.0.0.0 Backup Designated Rtr: 0.0.0.0
+PORT- KEY2 ACTIVE SAVE RETURN
ipospf