User Guide

Appendix C: WPIM-DI Configuration
C-8 Local Management User’s Guide
10. Use the arrow keys to highlight DI Enable. Press the SPACE bar to select On (Drop and Insert
function enabled), or Off (Drop and Insert function disabled), or diDataEnable (Drop and
Insert is enabled and the data that comes to the host goes to the DI port).
11. Use the arrow keys to highlight the SAVE command, then press ENTER. The message “Save
Done!” displays and Local Management saves the changes to memory. The host device reboots.
For further configuration, Local Management must be re-accessed.
WPIM-DI Interface Configuration
This screen is accessed from the WAN Physical Configuration screen. Refer to Figure C-4 and
proceed with the following steps to configure the WAN Interface through Local Management.
1. Access the WAN Interface Configuration screen by using the arrow keys to highlight the WAN
INT CONFIG option, then press ENTER.
2. If the correct Interface number to be configured is not displayed, enter it by typing the number
into the Interface Number field or select it using the SPACE bar, then press ENTER.
3. Unless the user sets the Max Xmit Unit, the WPIM-DI automatically sets the Max Xmit Unit
to the default after the active protocol (PPP or FR) is selected.
4. If you selected FR as the Protocol Manager, use the arrow keys to highlight FR LMI. Press the
SPACE bar to select T1.617-D, then press ENTER.
5. Make any other configurations as needed, such as ECP or CCP.
6. Use the arrow keys to highlight the SAVE command, then press ENTER. The message “Save
Done!” displays and Local Management saves the changes to memory.
The WAN configuration is complete. It takes up to 60 seconds for the WAN Interface to come out
of standby and for communications to begin.
NOTE
Upon saving this screen, the interface just configured is assigned to an application port
(CKT#) in the table on the right hand side of the screen.