User Guide

Appendix C: WPIM-DI Configuration
C-6 Local Management User’s Guide
WPIM-DI Configuration
This section provides step-by-step instructions for configuring the WPIM-DI to use a full or
fractional T-1 circuit in a PPP or Frame Relay environment. This simplified example assumes the
setup shown in Figure C-5 using two host platforms containing a WPIM-DI at Site #1 and a
WPIM-T1 at Site #2. Configurations may vary depending on the host platform.
Figure C-5 Full T-1 Configuration
The line configuration information shown in Table C-1 must be supplied by the service provider.
WPIM-DI Physical Configuration
Begin the configuration by accessing the WAN Physical Configuration screen (Figure C-1)
through Local Management. Proceed with the following steps:
1. Use the arrow keys to highlight the [WPIM] field at the bottom of the screen. Press the SPACE
bar to select the WPIM being configured, then press ENTER.
2. Use the arrow keys to highlight the MgrType field. Press the SPACE bar to choose the desired
Protocol Manager.
Table C-1 Telco Configuration Information
Configuration Information
Required by User
Configuration Information
Supplied by Service Provider
Line Coding B8ZS or AMI
Frame Type ESF or D4
Clock Source Loop Timing or Local Timing
DS0 (Timeslots)
Timeslots being used for each end of
the circuit
SITE #1
Telco Cloud
24 Timeslots
24 Timeslots
SITE #2
1482_05