User Guide

Local Management User’s Guide C-1
C WPIM-DI Configuration
This chapter explains how to configure the WPIM-DI through Local Management. It provides
instructions for setting up the WPIM-DI for full or fractional T-1 in a PPP environment, or for
configuring the WPIM-DI for Frame Relay.
The WAN Physical Configuration Screen
To access the WAN Physical Configuration screen from the Setup Menu screen, use the arrow keys
to highlight the WAN Setup option, then press ENTER. The screen shown in Figure C-1
displays.
Figure C-1 WAN Physical Configuration Screen
WPIM-DI Line Configuration Fields
NOTE
The service provider (i.e., AT&T, Sprint, MCI, NYNEX, etc.) determines the settings for
the following fields. Consult the service provider for the correct settings.
1482_01
SAVE
WAN INT CONFIG
RETURN
WPIM 1
Type: DI
WPIM #: 1
MgrType: [PPP]
Max VCs: 024
Next IF: 003
WAN PHYSICAL CONFIGURATION
NI/DI Timeslot View: [ Active]
NI/DI Line Coding: [ B8ZS]
NI/DI Frame Type: [ ESF]
NI Tx Clock Source: [Loop Timing]
NI/DI Line Buildout: [ 0 db]
NI/DI Loop-back: [None]
DI Enable: [Yes]
WPIM 1 Timeslot Configuration
003 D/I D/I D/I D/ID/I D/I D/I01-08
09-16
17-24
WPIM 1 LINE CONFIGURATION
D/I D/I D/I D/I D/ID/I D/I D/I
D/I D/I D/I D/I D/ID/I D/I D/I
[WPIM 1]
<host name> Local Management Flash Image Version: 02.xx.xx
REMOTE SETUP