User Guide

Appendix B: WPIM-E1 Configuration
B-6 Local Management User’s Guide
The line configuration information shown in Table B-1 must be supplied by the service provider.
WPIM-E1 Physical Configuration
Begin the WPIM-E1 configuration by accessing the WAN Physical Configuration screen through
Local Management (Figure B-1). Proceed with the following steps:
1. Use the arrow keys to highlight the [WPIM] field at the bottom of the screen. Press the
SPACEBAR to select the WPIM being configured, then press ENTER.
2. Use the arrow keys to highlight the MgrType. Press the SPACE bar to select PPP, then press
ENTER.
3. Use the arrow keys to highlight Timeslot View. Press the SPACEBAR to select New, then
press ENTER. The cursor moves to Timeslot #2 of the Timeslot Configuration Table.
4. Insert an interface number (see NOTE below) into every timeslot. Type the number, press
ENTER, then use the arrow keys to highlight the next timeslot field. Exit this field by using the
arrow keys. The cursor automatically moves to the E1 Line Coding field.
5. Use the arrow keys to highlight E1 Line Coding. Press the SPACEBAR to select HDB3 or
AMI.
6. Use the arrow keys to highlight E1 Frame Type. Press the SPACEBAR to select E1 or
E1-CRC.
Table B-1 Telco Configuration Information
Configuration Information Required By User
Configuration Information
Supplied By Service Provider
Line Coding HDB3 or AMI
Frame Type E1 or E1-CRC
Clock Source Loop Timing or Local Timing
NOTE
The value assigned to the timeslots is the interface being used for WAN
communication. The next available interface is displayed on the WAN Physical
Configuration screen (see Figure B-1).
The following three steps are based on information supplied by the service provider.
Consult the service provider for the correct settings.