User Guide

THE WAN INTERFACE CONFIGURATION SCREEN
Local Management User’s Guide B-5
THE WAN INTERFACE CONFIGURATION SCREEN
Figure B-4 displays the WAN Interface Configuration screen specific to the WPIM-E1 in PPP
mode.
Figure B-4 WAN Interface Configuration Screen
FULL E1 CONFIGURATION USING PPP
This section provides step-by-step instructions for configuring the WPIM-E1 to use a full E1
circuit in a PPP environment. This simplified example assumes the setup shown in Figure B-5
using a host platform containing a WPIM-E1 at Site #1. Configurations may vary depending on the
host platform.
Figure B-5 Full E1 Configuration
WAN INTERFACE CONFIGURATION
RETURNSAVE
Interface Number: 002
Max Xmit Unit: 1526
ProtMgrIface: [2]
Active Protocol: PPP
PPP MRU: 1520
ECP Enable: [Off]
ECP Status: Off
CCP Enable: [Off]
CCP Status: Off
Comp Ratio: 1:1
1484_04
<host name> Local Management Flash Image Version: 02.xx.xx
001
002
003
004
005
006
007
008
009
010
011
012
013
014
015
CKT# IF# LID STATE
018
019
020
021
022
023
024
025
026
027
028
029
030
031
032
CKT# IF# LID STATE
016
017
001 Enet UP
[1-32]
PORTS:
SITE 1
Telco Cloud
32 Timeslots
(31 customer-usable)
32 Timeslots
(31 customer-usable)
SITE 2
1484_05