User Guide

Appendix A: WPIM-SY Configuration
A-8 Local Management User’s Guide
Figure A-4 WPIM-SY WAN Interface Configuration Screen
4. Make any other changes as desired.
5. Use the arrow keys to highlight the SAVE command. Press ENTER. The message “Save
Done!” displays and Local Management saves the changes to memory.
The WAN configuration is complete. Communications between the WPIM-SY and the service
provider’s switch takes approximately 1 to 2 minutes to begin. A status of Inactive displays until
both ends of the PVC (Permanent Virtual Circuit) are configured. Once both end devices have
negotiated link management with the switches, the status field reads Active.
<host name> Local Management Flash Image Version: 02.XX.XX
WAN INTERFACE CONFIGURATION
CKT# IF # LID STATE CKT# IF # LID STATE
Interface Number: 000 001 001 Enet UP 017
Max Xmit Unit: 0 002 018
ProtMgrIface: [3] 003 019
Active Protocol: FR 004 020
FR LMI: [ANSI_94] 005 021
DLCI Address: 0 006 022
DLCI DCP En: 007 023
DLCI DCP Stat: 008 024
Comp Ratio: 009 025
Circuit State: [Invalid] 010 026
011 027
012 028
013 029
014 030
PORTS: 015 031
SAVE [1-32] RETURN 016 032
wanintsy