User Guide

PPP CONFIGURATION

Local Management User’s Guide A-5

6. Use the arrow keys to highlight FORCE RTS True. Press the SPACE bar to set to ENABLE.

7. Use the arrow keys to highlight FORCE DTR True. Press the SPACE bar to set to ENABLE.

8. Use the arrow keys to highlight the SAVE command. Then press ENTER. The message “Save

Done!” displays and Local Management saves the changes to memory and the device reboots.

Local Management must be reaccessed before any other configurations may be made.

9. Proceed to the next section for the WPIM-SY Interface Configuration.

WPIM-SY Interface Conﬁguration

This screen is accessed through the WAN Physical Conﬁguration screen. Refer to Figure A-2 and

proceed with the following steps to conﬁgure the WAN Interface through Local Management.

1. Access the WAN Interface Configuration screen by using the arrow keys to highlight the WAN

Int Config option, then press ENTER.

2. Use the arrow keys to highlight Interface Number. Set the WAN connection Interface Number

by typing the same number found in the Interfaces field on the WAN Physical Configuration

screen into the Interface Number field, or use the SPACE bar to toggle to the correct Interface

Number, then press ENTER.

3. Use the arrow keys to highlight ECP Enable. Press the SPACEBAR to select On to enable

encryption.

4. Use the arrow keys to highlight CCP Enable. Press the SPACEBAR to select On to enable

compression.

5. Make any other changes as desired.

6. Use the arrow keys to highlight the SAVE command. Press ENTER. The message “Save

Done!” displays and Local Management saves the changes to memory.

The WAN conﬁguration is complete. It takes up to 60 seconds for the WAN Interface to come out

of standby and for communications to begin.

NOTE

Set FORCE CTS and FORCE DSR to YES only if the CSU/DSU does not support

these ﬂow control terms.