User Guide

MIB Navigator
3-24 Local Management User’s Guide
ds1alarm:
Syntax: ds1alarm
ds1alarm -ea <WANID>
ds1alarm -da <WANID>
ds1alarm -er <WANID>
ds1alarm -dr <WANID>
ds1alarm -et <WANID>
ds1alarm -dt <WANID>
ds1alarm -sec <WANID> <VALUE>
ds1alarm -sei <WANID> <VALUE>
ds1alarm -sbr <WANID> <VALUE>
ds1alarm -sbi <WANID> <VALUE>
Description: The command “ds1alarm” with no options displays status information.
Options: <WANID> Is either ALL to apply the command to all DS1 circuits, or it
is the specific WAN physical identifier associated with the DS1
circuit.ds1alarm (with no options) displays status information.
ds1alarm -ea Enables the WAN DS1 Alarms Admin.
ds1alarm -da Disables the WAN DS1 Alarms Admin.
ds1alarm -er Enables the WAN DS1 Alarms Auto Recovery Feature.
ds1alarm -dr Disables the WAN DS1 Alarms Auto Recovery Feature.
ds1alarm -et Enables the WAN DS1 Alarms Traps Feature.
ds1alarm -dt Disables the WAN DS1 Alarms Traps Feature.
ds1alarm -sec Sets the Errored Seconds Threshold Count to VALUE.
ds1alarm -sei Sets the Errored Seconds Threshold Interval to VALUE.
ds1alarm -sbr Sets the Bipolar Violations Threshold Rate to VALUE.
ds1alarm -sbi Sets the Bipolar Violations Threshold Interval to
VALUE.