User Guide

Spoofing Command
Local Management User’s Guide 3-15
setspoof <IF> NB20 <ON/OFF>
setspoof <IF> SP <ON/OFF>
Description:The setspoof command allows the user to enable or disable
spoofing on all the listed packet types or on a specific packet type. Where
TIME INTERVAL: T=n*30(sec), where n belongs to the domain of
natural numbers (1,2,3....), set spoofing on a time interval basis (in
seconds); PACKETS COUNT: N - any natural number (except 1) Spoofs
N packets, then allows the next packet through.
ON: enable spoofing
OFF: disable spoofing
Examples:
-> setspoof 4 on - will enable spoofing for all packet types on interface
4 using the default settings, unless enabled differently via a specific
packet type.
-> setspoof 6 IPXSAP 1 - will enable IPX SAP spoofing on interface 6.
-> setspoof 8 IPXRIP 0 - will disable IPX RIP spoofing on interface 8.
-> setspoof 10 IPRIP 36000 - will spoof IP RIP on interface 10 on a 10
hour interval basis. (An IP RIP packet will be allowed through every 10
hours)
-> setspoof 4 WDP 40 - will spoof on a count of 40 watchdog packets on
interface 4. (A WPD will be allowed through every 40 WDP packets)
Options: Not Applicable
Example:
The example below shows the syntax used.
MIBNav-> pppsecurity 7 "CHAP" 1 "localcyberswitch" "localsecurityword"
MIBNav-> pppsecurity 7 "CHAP" 2 "remotecyberswitch" "remotesecurityword"