Installation guide

Using the Reset Switch
SecureStack C3 Installation Guide 4-7
Using the Reset Switch
Ifyouforgettheswitchloginpassword,usetheResetswitchtoresettheloginpassword
tothedefaultpassword,asdescribedinthefollowingprocedure.
Figure 4-23 Reset Switch
Toresettheswitchpassword,refertoFigure 4‐23andproceedasfollows:
1. Press‐and‐holdtheResetswitchwhiletheswitchisoperational.This
changeofthe
loginpasswordtothedefaultpasswordwillbeindicatedviaCLIonly.
2. Logontoswitchmanagement.YoucannowlogontotheswitchviatheConsoleport
andassignanewpasswordusingthecommandlineinterface(CLI).
3. ToaccessswitchmanagementfromyourlocalPC, terminal,or
modemconnection,
refertotheSecureStackC3ConfigurationGuideforinstructionsonhowtologinand
enteranewpassword.TheguideisavailableonlineundertheSecureStackcategory
at:http://www.enterasys.com/support/manuals
Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed
in“GettingHelp”onpage xviii.

1 Reset switch
Note: Notify the system manager before changing the password.
STACK UP
STACK DOWN
À