Installation guide

Rack Mounting the Switch
3-10 Hardware Installation
Attaching Brackets and Installing in Rack
Proceedasfollowstoinstalltheswitchintoa19‐inchrack:
1. Attachtherackmountbracketstothe switch,asshowninFigure 3‐7,usingtheeight
M3x6mmflatheadscrewsshippedwiththeswitch.
Figure 3-7 Attaching the Rackmount Brackets
2. Withthemountingbracketsattached,positiontheswitchbetweentheverticalframe
membersofthe
19‐inchrackasshowninFigure 3‐8.Thenfastentheswitchsecurely
totheframeusingfourmountingscrews(usersupplied).
Figure 3-8 Fastening the Switch to the Rack
3. Ifyouare installingthisswitchinastackedconfiguration,repeatthisprocedurefor
eachswitchuntilallswitcheshavebeeninstalledinthestack,thenproceedto
“ConnectingHigh‐SpeedStackingCables”onpage 3‐11.Otherwise,proceedto
“ConnectingACandRPS‐SYSPower”onpage 3‐15.
1 Rackmount brackets 2 M3x6 mm flathead screws
1 Rails of 19-inch rack 2 Mounting screws (supplied by user)