Installation guide

Installing the Switch on a Flat Surface
3-6 Hardware Installation
2. Removethe cablesconnectedtotheMini‐GBIC.
3. LocatethereleasetabunderthefrontendoftheMini‐GBIC.Forthetypeof
Mini‐GBICshowninFigure 3‐3, pushinonthereleasetabasfarasitwillgotorelease
theMini‐GBICfrom theportslot.
ForthetypeofMini‐GBICshowninFigure 3‐4,pull
outonthereleasetabtoreleasetheMini‐GBICfromthe portslot.
4. GraspthesidesoftheMini‐GBICandpullitstraightoutoftheportslot.
IfstoringorshippingaMini‐GBICwhichhas
afiber‐opticconnector,insertitsprotective
dustcovertoprotecttheendsofthefiber‐opticfibersfromdustorcontamination.
Installing the Switch on a Flat Surface
Wheninstallingtheswitchonaflatsurface,theinstallationoftherubber feetis
recommendedtopreventtheswitchfromslidingonaflatsurface.Installingtherubber
feetisoptionalifyouareinstallingtheswitchinarack.Toinstalltherubberfeet,proceed
to“Installingthe
RubberFeet”instructionsbelow.Forinstructionstorackmountthe
switch,proceedto“RackMountingtheSwitch”onpage 3‐9.
Installing the Rubber Feet
Toinstalltherubberfeet,refertoFigure 3‐5andproceedasfollows:
1. Placetheswitchonitsbackonasturdyflatsurfacetogainaccesstothebottomofthe
chassis.
2. Removethe fourrubberfeetfromtheirplasticbagintheshipping box.
3. Locatethefourmarkedlocationson
thebottomfourcornersofthechassis.