Installation guide

Overview
1-2 Introduction
•SFPslotsthatprovideyouwiththeoptionofinstallingSmallFormPluggable(SFP)
Mini‐GBICsfor1000BASE‐SX/LXfiber‐opticconnectionsand1000BASE‐Tcopper
connections.
•Rearpanelconnectorsforhigh‐speedconnectionsinastackconfiguration
•RearpanelRedundantPowerSupplyconnectorforconnectiontoaSecureStack
redundantpowersupply
system(C2RPS‐SYS)usingtheappropriatecable
(C2RPS‐PSM).
The10/100/1000 Mbpsfixedfrontpanelportscanoperateineitherhalf‐duplexorfull‐
duplexmode,asdeterminedbyAuto‐Negotiation.
Figure 1-1 C3G124-24 Stackable Switch
Caution: The C3G124-24 and C3G124-48 are not PoE-compliant devices. Do not
connect a SecureStack PoE Redundant Power System (C2RPS-POE) to the power
connector. Otherwise, damage to the device may result.
Precaución: Los dispositivos C3G124-24 y C3G124-48 no cumplen con el estándar PoE
(power over ethernet). No conecte una fuente de poder redundante (RPS) SecureStack
PoE (C2RPS-POE) al cable de corriente. De lo contrario, el dispositivo puede dañarse.
Note: The Mini-GBIC ports cannot be active simultaneously with their corresponding
10/100/1000BASE-T ports. For example, if SFP port 24 establishes a link first on the
C3G124-24, the 10/100/1000BASE-T built-in RJ45 port 24 is not available and vice-versa.
1 DB9 RS232 Console port connector 6 Mini-GBIC port status LEDs
2 Status LEDs 7 Two ports for stack connections
3 Twenty-four RJ45, 10/100/1000 Mbps ports 8 Reset switch
4 RJ45 port status LED
S 9 AC power input connector
5 Four slots for SFP interface modules (Mini-GBICs) 10 C2RPS-SYS connection
C3G124-24