Specifications

Reviewing and Selecting a Boot Firmware Image
SecureStack C3 Configuration Guide 3-41
Reviewing and Selecting a Boot Firmware Image
Purpose
Todisplayandsettheimagefiletheswitchloadsatstartup.TheC3switchallowsyouto
downloadandstoreabackupimage,whichcanbeselectedasthestartupimagebyusingthe
commandsdescribedinthissection.
Commands
Thecommandsusedtoreviewandselecttheswitch’sbootimagefilearelistedbelow.
show boot system
Usethiscommandtodisplaythefirmwareimagetheswitchloadsatstartup.
Syntax
show boot system
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaytheswitch’sbootfirmwareimage:
C3(su)->show boot system
Current system image to boot: bootfile
For information about... Refer to page...
show boot system 3-41
set boot system 3-42