Specifications

show inlinepower
SecureStack C3 Configuration Guide 3-35
show inlinepower
UsethiscommandtodisplayswitchPoEproperties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayswitchPoEproperties.Inthiscase,units1,3,and5arePoE
modules,sotheirpowerconfigurationsdisplay:
C3(su)->show inlinepower
Unit Status Power(W) Consumption(W) Usage(%) Threshold(%) Trap
---- ------ -------- -------------- -------- ------------ ----
2 auto 360 0.00 0.00 80 enable
4 auto 360 0.00 0.00 80 enable
8 auto 360 5.20 1.44 80 enable
set inlinepower threshold
UsethiscommandtosetthePoEusagethresholdonaspecifiedunit.
Syntax
set inlinepower threshold usage-threshold module-number
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
usage‐threshold Specif iesaPoEthresholdasapercentageoftotalsystempowerusage.
Validvaluesare 11to100.
module‐number SpecifiestheunitonwhichtosetthePoEthreshold.