Specifications

Configuring Power over Ethernet (PoE)
3-34 Basic Configuration
Configuring Power over Ethernet (PoE)
Purpose
ToreviewandsetPoEparameters,includingthepoweravailabletothesystem,theusage
thresholdforeachmodule,whetherornotSNMPtrapmessageswillbesentwhenpowerstatus
changes,andper‐portPoEsettings.
Commands
ThecommandsusedtoreviewandsetPoEportparametersarelistedbelow.
Important Notice
This section applies only to PoE-equipped SecureStack C3 switches. Consult the Installation Guide shipped
with your product to determine if it is PoE-equipped.
For information about... Refer to page...
show inlinepower 3-35
set inlinepower threshold 3-35
set inlinepower trap 3-36
show port inlinepower 3-36
set port inlinepower 3-37