Specifications

Activating Licensed Features
3-30 Basic Configuration
4. Enablethelicenseontheswitchmasterunitlast,usingthesetlicensecommand.
Adding a New Member to a Licensed Stack
WhenaSecureStackC3switchwithoutalicenseisaddedtoastackthathaslicensingenabled,the
portsonthenewswitchwillnotpasstrafficuntilalicensehasbeenappliedtothenewswitch.To
addanewmembertoalicensedstack:
1. Obtainalicenseforthe
newswitchfromtheEnterasysCustomerPortal.
2. Addthenewunittothestack,followingtheprocedurein“AddingaNewUnittoanExisting
Stack”onpage2‐3.
3. Usethesetlicensecommandtoinstallandactivatethenewswitch’slicense.Thenewswitch
willthenjointhestack
anditsportswillbeattached.
Alternatively,youcaninstallandactivatethenewswitch’slicensefirst,beforeaddingtheswitch
tothestack.
Clearing, Showing, and Moving Licenses
Licensescanbedisplayed,applied,andclearedonlywiththe licensecommandsdescribedinthis
chapter.Generalconfig urationcommandssuchasshowconfigorclearconfigdonotapplyto
licenses.
Everylicenseisassociatedwithaspecifichardwareplatform,basedontheserialnumberofthe
hardwareplatform.Ifyou
needtomovealicensefromonehardwareplatformtoanother,you
mustcontactEnterasysCustomerSupporttoarrangeforre‐hostingofthelicense.
Commands
Thecommandsusedtoactivateandverifylicensedfeaturesarelistedbelow.
For information about... Refer to page...
set license 3-31
show license 3-32
clear license 3-33