Specifications

set maclock trap
SecureStack C3 Configuration Guide 21-55
Example
ThisexampleshowshowtomoveallcurrentfirstarrivalMACstostaticentriesonportsge.3.1‐40:
C3(rw)->set maclock move ge.3.1-40
set maclock trap
UsethiscommandtoenableordisableMAClocktrapmessaging.
Syntax
set maclock trap port-string {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Whenenabled,thisfeatureauthorizestheswitchtosendanSNMPtrapmessageifanendstation
isconnectedthatexceedsthemaximumvaluesconfiguredusingthesetmaclockfirstarrivaland
setmaclockstaticcommands.ViolatingMACaddressesaredroppedfromthedevice’srouting
table.
Example
ThisexampleshowshowtoenableMAClocktrapmessagingonfe.2.3:
C3(su)->set maclock trap fe.2.3 enable
port‐string SpecifiestheportonwhichMAClocktrapmessagingwillbeenabledor
disabled.Foradetaileddescriptionofpossibleport‐stringvalues,referto
“PortStringSyntaxUsedintheCLI”onpage 4‐1.
enable|disable EnablesordisablesMAClocktrap messaging.