Specifications

show eapol
SecureStack C3 Configuration Guide 21-19
Thisexampleshowshowtoresetreauthenticationcontroltodisabledonportsfe.1.1‐3:
C3(su)->clear dot1x auth-config reauthenabled fe.1.1-3
Thisexampleshowshowtoresetthe802.1Xquietperiodto60secondsonportsfe.1.1‐3:
C3(su)->clear dot1x auth-config quietperiod fe.1.1-3
show eapol
UsethiscommandtodisplayEAPOLstatusorsettingsforoneormoreports.
Syntax
show eapol [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,onlyEAPOLenablestatuswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayEAPOLstatusforportsfe.1.1‐3:
C3(su)->show eapol fe.1.1-3
EAPOL is disabled.
Port Authentication State Authentication Mode
-------- -------------------- --------------------
fe.1.1 Initialized Auto
fe.1.2 Initialized Auto
fe.1.3 Initialized Auto
Table 21‐2providesanexplanationofthecommandoutput.Fordetailsonusingtheseteapol
commandtoenabletheprotocolandassignanauthenticationmode,referto“seteapol”on
page 21‐21.
port‐string (Optional)DisplaysEAPOLstatusforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsed
intheCLI”onpage 4‐1.
Table 21-2 show eapol Output Details
Output What It Displays...
Port Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 4-1.