Specifications

set radius
SecureStack C3 Configuration Guide 21-7
Ifrealmisnotspecified,theanyaccessrealmwillbeused.
Mode
Switchcommand,read‐write.
Usage
TheSecureStackC3deviceallowsupto10RADIUSaccountingserverstobeconfigured,withup
totwoserversactiveatanygiventime.
TheRADIUSclientcanonlybeenabledontheswitchonceaRADIUSserverisonline,anditsIP
address(es)hasbeenconfiguredwiththesamepassword
theRADIUSclientwilluse.
Examples
ThisexampleshowshowtoenabletheRADIUSclientforauthenticatingwithRADIUSserver1at
IPaddress192.168.6.203,UDPauthenticationport1812,andanauthenticationpasswordof
“pwsecret.”Aspreviouslynoted,the“serversecret”passwordenteredheremustmatchthat
alreadyconfiguredastheRead‐Write(rw)passwordonthe
RADIUSserver:
C3(su)->set radius server 1 192.168.6.203 1812 pwsecret
ThisexampleshowshowtosettheRADIUStimeoutto5seconds:
C3(su)->set radius timeout 5
ThisexampleshowshowtosetRADIUSretriesto10:
C3(su)->set radius retries 10
Thisexampleshowshowtoforceanymanagement‐access totheswitch(Telnet,web,SSH)to
authenticatethroughaRADIUSserver.Theallparameterattheendofthecommandmeansthat
anyofthedefinedRADIUSserverscanbeusedforthisAuthentication.
C3(rw)->set radius realm management-access all