Specifications

show radius
SecureStack C3 Configuration Guide 21-5
show radius
UsethiscommandtodisplaythecurrentRADIUSclient/serverconfiguration.
show radius [status | retries | timeout | server [index | all]]
Parameters
Defaults
Ifnoparametersarespecified,allRADIUSconfigurationinformationwillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayRADIUSconfigurationinformation:
C3(rw)->show radius
RADIUS status: Enabled
RADIUS retries: 3
RADIUS timeout: 20 seconds
RADIUS Server IP Address Auth-Port Realm-Type
-------------- ---------- --------- -----------------
10 172.16.20.10 1812 management-access
Table 21‐1providesanexplanationofthecommandoutput.
status (Optional)DisplaystheRADIUSserver’senablestatus.
retries (Optional)DisplaysthenumberofretryattemptsbeforetheRADIUSserver
timesout.
timeout (Optional)Displaysthemaximumamountoftime(inseconds)toestablish
contactwiththeRADIUSserverbeforeretryattemptsbegin.
server(Optional)
DisplaysRADIUSserverconfigurationinformation.
index|all Forusewiththeserverparametertoshowserverconfigurationforall
serversoraspecificRADIUSserverasdefinedbyanindex.
Table 21-1 show radius Output Details
Output What It Displays...
RADIUS status Whether RADIUS is enabled or disabled.
RADIUS retries Number of retry attempts before the RADIUS server times out. The default value of 3
can be reset using the set radius command as described in “set radius” on
page 21-6.
RADIUS timeout Maximum amount of time (in seconds) to establish contact with the RADIUS server
before retry attempts begin. The default value of 20 can be reset using the set
radius command as described in “set radius” on page 21-6.
RADIUS Server RADIUS server’s index number, IP address, and UDP authentication port.