Specifications

show ipv6 ospf virtual-link
SecureStack C3 Configuration Guide 20-49
show ipv6 ospf virtual-link
ThiscommanddisplaystheOSPFv3virtualinterfaceinforma tionforaspecificareaandneighbor.
Syntax
show ipv6 ospf virtual-link areaid neighborid
Parameters
Defaults
None.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Example
ThisinformationdisplaysvirtuallinkinformationforareaID10andtheneighborwithrouterID
of3.3.3.3.Table 20‐13onpage 20‐49describestheoutputfields.
C3(su)->router(Config)#show ipv6 ospf virtual-link 10 3.3.3.3
Area ID 10
Neighbor IP Address 3.3.3.3
Hello Interval 10
Dead Interval 40
Iftransit Delay Interval 1
Retransmit Interval 5
State DOWN
Metric 0
Neighbor State DOWN
areaid EntertheareaIDinIPaddressformat(dotted‐quad)orasadecimal
value.
neighborid SpecifytheneighborbyitsrouterID,specifiedin32‐bitdottedquad
format.
Table 20-13 Output of show ipv6 ospf virtual-link Command
Output... What it displays...
Area ID The area id of the requested OSPFv3 area.
Neighbor Router ID The input neighbor Router ID.
Hello Interval The configured hello interval for the OSPFv3 virtual interface.
Dead Interval The configured dead interval for the OSPFv3 virtual interface.
Iftransit Delay Interval The configured transit delay for the OSPFv3 virtual interface.
Retransmit Interval The configured retransmit interval for the OSPFv3 virtual
interface.
State The OSPFv3 Interface States are: down, loopback, waiting, point-
to-point, designated router, and backup designated router. This is
the state of the OSPFv3 interface.
Metric The metric of this virtual link.