Specifications

show ipv6 ospf stub table
20-48 OSPFv3 Configuration
show ipv6 ospf stub table
ThiscommanddisplaystheOSPFv3stubtable,ifOSPFv3isinitializedontheswitch.
Syntax
show ipv6 ospf stub table
Parameters
None.
Defaults
None.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Example
ThisexampledisplaystheOSPFv3stubtableinformation.Table 20‐12onpage 20‐48describesthe
outputfields.
C3(su)->router# show ipv6 ospf stub table
AreaId TypeofService Metric Val Import SummaryLSA
---------------- ------------- ---------- -----------------
0.0.0.20 Normal 1 Enable
Table 20-12 Output of show ipv6 ospf stub table Command
Output... What it displays...
Area ID A 32-bit identifier for the created stub area.
Type of Service Type of service associated with the stub metric. For this release,
Normal TOS is the only supported type.
Metric Val The metric value is applied based on the TOS. It defaults to the
least metric of the type of service among the interfaces to other
areas. The OSPFv3 cost for a route is a function of the metric
value.
Import Summary LSA Controls the import of summary LSAs into stub areas.