Specifications

show ipv6 ospf neighbor
SecureStack C3 Configuration Guide 20-45
show ipv6 ospf neighbor
ThiscommanddisplaysinformationaboutOSPFv3neighbors.
Syntax
show ipv6 ospf neighbor [interface {vlan vlanid | tunnel tunnelid}] [neighborid]
Parameters
Defaults
Whennoparametersarespecified,informationaboutallneighborsisdisplayed.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Usage
IfyoudonotspecifyaneighborrouterID,theoutputdisplayssummaryinformationinatable.If
youspecifyaninterfaceortunnel,onlytheinformationforthat interfaceortunneldisplays.
WhenyouspecifyaneighborbyrouterID,detailedinformationabouttheneighbordisplays.
Theinformationisdisplayed
onlyifOSPFv3isenabledandtheinterfacehasaneighbor.
Examples
Thisexampleillustratesthesummaryinformationdisplayedwhennoneighborisspecified.
Table 20‐9onpage 20‐45describestheoutputfields.
C3(su)->router#show ipv6 ospf neighbor
Router ID Priority Intf Interface State Dead
ID Time
---------------- -------- ----- ----------- ---------------- ----
3.3.3.3 1 3 Vlan 36 Full/DR 32
6.6.6.6 1 456 Tunnel 0 Full/PtP 31
interface (Optional)Restrictstheoutputdisplaytoaspecificinterface.
vlanvlanid SpecifytheVLANinterfacetodisplayinformationabout.
tunneltunnelid Specifythetunnelinterfacetodisplay
neighborid (Optional)SpecifytheneighborbyitsrouterID,specifiedin32‐bit
dottedquadformat.
Table 20-9 Output of show ipv6 ospf neighbor Command
Output... What it displays...
Router ID Shows the 4-digit dotted-decimal number of the neighbor router.
Priority Displays the OSPFv3 priority for the specified interface. The
priority of an interface is a priority integer from 0 to 255. A value of
'0' indicates that the router is not eligible to become the
designated router on this network.
Intf ID Shows the interface ID of the neighbor.
Interface Shows the interface of the local router in slot/port format.