Specifications

show ipv6 ospf interface
SecureStack C3 Configuration Guide 20-41
show ipv6 ospf interface
ThiscommanddisplaysinformationaboutOSPFv3interfaces.
Syntax
show ipv6 ospf interface {vlan vlanid | tunnel tunnelid | loopback loopid}
Parameters
Defaults
None.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Examples
ThisexampledisplaysinformationaboutOSPFv3routinginterfaceVLAN80.Table 20‐7on
page 20‐42explainsthecontentoftheoutputfields.
C3(su)->router>show ipv6 ospf interface vlan 80
IPv6 Address FE80::211:88FF:FE56:5D8F
ifIndex 430
OSPF Admin Mode Enable
OSPF Area ID 0.0.0.20
Router Priority 1
Retransmit Interval 5
Hello Interval 10
Dead Interval 40
LSA Ack Interval 1
Iftransit Delay Interval 1
Authentication Type None
Metric Cost 10 (computed)
OSPF Mtu-ignore Disable
OSPF Interface Type broadcast
State designated-router
Designated Router 2.2.2.2
Backup Designated Router 0.0.0.0
Number of Link Events 2
Thisexampledisplaysinformationabouttunnelinterface0.Table 20‐7onpage 20‐42explainsthe
contentoftheoutputfields.
C3(su)->router#show ipv6 ospf interface tunnel 0
IPv6 Address FE80::5000:2
ifIndex 456
OSPF Admin Mode Enable
OSPF Area ID 0.0.0.0
Router Priority 1
Retransmit Interval 5
Hello Interval 10
Dead Interval 40
LSA Ack Interval 1
vlanvlanid SpecifiestheVLANinterfacetodisplayinformationabout.
tunneltunnelid Specifiesthetunnelinterfacetodisplayinformationabout.
loopbackloopid Specifiestheloopbackinterfacetodisplayinformationabout.