Specifications

show ipv6 ospf abr
20-34 OSPFv3 Configuration
show ipv6 ospf abr
ThiscommanddisplaysOSPFv3routestoreachareaborderrouters.
Syntax
show ipv6 ospf abr
Parameters
None.
Defaults
None.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Example
TheoutputofthiscommandisdescribedinTable 20‐3onpage 20‐34.
C3(su)->router# show ipv6 ospf abr
Type Router Id Cost Area ID Next Hop Next Hop
Intf
----- -------------- ---- ------------ -------------------------------- --------
INTRA 82.15.0.1 10 0.0.0.10 FE80::200:2DFF:FEE6:FB6B Vlan 48
Default Metric Shows the metric value for the default route advertised into the
NSSA.
Default Metric Type Shows the metric type for the default route advertised into the
NSSA.
Translator Role Shows the NSSA translator role of the ABR, which is always or
candidate.
Translator Stability Interval Shows the amount of time that an elected translator continues to
perform its duties after it determines that its translator status has
been deposed by another router.
Translator State Shows whether the ABR translator state is disabled, always, or
elected.
Table 20-2 Output of show ipv6 ospf area Command (Continued)
Output... What it displays...
Table 20-3 Output of show ipv6 ospf abr Command
Output... What it displays...
Type The type of the route to the destination, which is one of the
following values:
INTRA — Intra-area route
INTER — Inter-area route
Router ID Router ID of the destination.