Specifications

show ipv6 ospf area
20-32 OSPFv3 Configuration
show ipv6 ospf area
ThiscommanddisplaysinformationaboutthespecifiedOSPFv3area.
Syntax
show ipv6 ospf area areaid
Parameters
Defaults
None.
New LSAs Originated Shows the number of new link-state advertisements that have
been originated.
LSAs Received Shows the number of link-state advertisements received
determined to be new instantiations.
External LSDB Limit Shows the maximum number of non-default AS-external-LSAs
entries that can be stored in the link-state database.
Default Metric Default value for redistributed routes.
Maximum Paths Shows the maximum number of paths that OSPF can report for a
given destination.
Default Route Advertise Indicates whether the default routes received from other source
protocols are advertised or not.
Always Shows whether default routes are always advertised.
Metric Shows the metric for the advertised default routes. If the metric is
not configured, this field is blank.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Redistributing This field is a heading and appears only if you configure the
system to take routes learned from a non-OSPF source and
advertise them to its peers.
Source Shows source protocol/routes that are being redistributed.
Possible values are static, connected, BGP, or RIP.
Metric Shows the metric of the routes being redistributed.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Tag Shows the decimal value attached to each external route.
Subnets For redistributing routes into OSPF, the scope of redistribution for
the specified protocol.
Distribute-List Shows the access list used to filter redistributed routes.
Table 20-1 Output of show ipv6 ospf Command (Continued)
Output... What it displays...
areaid EntertheareaIDinIPaddressformat(dotted‐quad)orasadecimal
value.