Specifications

show ipv6 ospf
SecureStack C3 Configuration Guide 20-31
C3(su)->router# show ipv6 ospf
Router ID 2.2.2.2
OSPF Admin Mode Enable
ASBR Mode Enable
ABR Status Enable
Exit Overflow Interval 0
External LSA Count 0
External LSA Checksum 0
New LSAs Originated 89
LSAs Received 177
External LSDB Limit No Limit
Default Metric Not Configured
Maximum Paths 4
Default Route Advertise Disabled
Always FALSE
Metric
Metric Type External Type 2
Redistributing
Source Connected
Metric Not Configured
Metric Type 2
Tag 0
Redistributing
Source static
Metric Not Configured
Metric Type 2
Tag 0
Note: Some of the information in Table 20-1 displays only if you enable OSPFv3 and configure
certain features.
Table 20-1 Output of show ipv6 ospf Command
Output... What it displays...
Router ID Is a 32 bit integer in dotted decimal format identifying the router,
about which information is displayed. This is a configured value.
OSPF Admin Mode Shows whether the administrative mode of OSPF in the router is
enabled or disabled. This is a configured value.
ASBR Mode Reflects whether the ASBR mode is enabled or disabled. Enable
implies that the router is an autonomous system border router.
Router automatically becomes an ASBR when it is configured to
redistribute routes learnt from other protocol. The possible values
for the ASBR status is enabled (if the router is configured to re-
distribute routes learnt by other protocols) or disabled (if the router
is not configured for the same).
ABR Status Shows whether the router is an OSPF Area Border Router.
Exit Overflow Interval Shows the number of seconds that, after entering Overflow State,
a router will attempt to leave Overflow State.
External LSA Count Shows the number of external (LS type 5) link-state
advertisements in the link-state database.
External LSA Checksum Shows the sum of the LS checksums of external link-state
advertisements contained in the link-state database.