Specifications

Interface Configuration Commands
20-22 OSPFv3 Configuration
Interface Configuration Commands
Purpose
ThesecommandscanbeusedtoconfigureOSPFv3routinginterfaceparameters.
Commands
ipv6 ospf enable
ThiscommandenablesOSPFv3onarouterinterfaceoraloopbackinterface.
Syntax
ipv6 ospf enable
no ipv6 ospf enable
Parameters
None.
Defaults
OSPFv3isdisabledbydefault.
Mode
Routerinterfaceconfiguration:C3(su)‐>router(configif(Vlan1))#
Usage
UsethiscommandtoenableOSPFv3onarouterVLANinterfaceoronaloopbackinterface.Use
thenoformofthiscommandtodisableOSPFv3onaninterface.
For information about... Refer to page...
ipv6 ospf enable 20-22
ipv6 ospf areaid 20-23
ipv6 ospf cost 20-24
ipv6 ospf dead-interval 20-24
ipv6 ospf hello-interval 20-25
ipv6 ospf mtu-ignore 20-26
ipv6 ospf network 20-26
ipv6 ospf priority 20-27
ipv6 ospf retransmit-interval 20-28
ipv6 ospf transmit-delay 20-28
Note: In order for OSPFv3 to run on an interface, IPv6 must be explicitly enabled on the interface
using the ipv6 enable command.