Specifications

Area Configuration Commands
20-10 OSPFv3 Configuration
Area Configuration Commands
Purpose
Thesecommandsareusedtoconfigureareaparameters.
Commands
area default-cost
Thiscommandconfiguresthedefaultcostforthesummarydefaultroutegeneratedbythearea
borderrouterintothestuborNSSAarea.
Syntax
area areaid default-cost cost
no area areaid default-cost
Parameters
Defaults
None.
For information about... Refer to page...
area default-cost 20-10
area nssa 20-11
area nssa default-info-originate 20-12
area nssa no-redistribute 20-12
area nssa no-summary 20-13
area nssa translator role 20-14
area nssa translator-stab-intv 20-15
area range 20-15
area stub 20-16
area stub no-summary 20-17
area virtual-link 20-18
area virtual-link dead-interval 20-18
area virtual-link hello-interval 20-19
area virtual-link retransmit-interval 20-20
area virtual-link transmit-delay 20-20
areaid EntertheareaIDinIPaddressformat(dotted‐quad)orasadecimal
value.
cost Therangeofcostisbetween1and16777215.