Specifications

show ipv6 route preferences
SecureStack C3 Configuration Guide 18-27
show ipv6 route preferences
Thiscommandshowsthepreferencevalueassociatedwiththetypeofroute.
Syntax
show ipv6 route preference
Parameters
None.
Defaults
None.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Routeruserexecution:C3(su)‐>router>
Usage
Lowernumbershaveagreaterpreference.Aroutewithapreferenceof255cannotbeusedto
forwardtraffic.
Thedefaultpreferencevalueforstaticroutescanbesetwiththeipv6routedistancecommand.
Thedistanceforaspecificstaticroutecanbesetwiththeipv6routecommand.
Example
Thefollowingexampleshowstheoutputofthiscommand.Table 18‐3describesthefieldsofthe
output.
C3(su)->router#show ipv6 route preferences
Local 0
Static 1
OSPF Intra 8
IPv6 prefix/prefix-length The IPv6 prefix and prefix length of the destination IPv6 network
corresponding to this route.
[ Preference / Metric ] The administrative distance (preference) and cost (metric)
associated with this route.
Tag Displays the decimal value of the tag associated with a
redistributed route, if it is not 0.
via Next-hop The outgoing router IPv6 address to use when forwarding traffic to
the next router, if any, in the path toward the destination.
Interface The outgoing router interface to use when forwarding traffic to the
next destination.
Table 18-2 Output of the show ipv6 route Command (Continued)
Output... What it displays...
Note: The configuration of NSSA preferences is not supported in this release.