Specifications

show ipv6 route
18-26 IPv6 Configuration
Defaults
Ifnoparametersareentered,informationaboutallactiveIPv6routesisdisplayed.
Mode
Routerprivilegedexecution:C3(su)‐>router#
Routeruserexecution:C3(su)‐>router>
Usage
UsethiscommandtodisplayIPv6routingtableinformationforactiveroutes.
Example
ThisexampledisplaysallactiveIPv6routes.
C3(su)->router>show ipv6 route
IPv6 Routing Table - 5 entries
Codes: C - connected, S - static
O - OSPF Intra, OI - OSPF Inter, OE1 - OSPF Ext 1, OE2 - OSPF Ext 2
ON1 - OSPF NSSA Ext Type 1, ON2 - OSPF NSSA Ext Type 2
S ::/0 [1/0]
via FE80::2D0:B7FF:FE2C:7694, Vlan 6
C 3FFE:501:FFFF:100::/64 [0/0]
via ::, Vlan 6
C 3FFE:501:FFFF:101::/64 [0/0]
via ::, Vlan 7
C 3FFE:501:FFFF:108::/64 [0/0]
via ::, Vlan 6
S 3FFE:501:FFFF:109::/64 [1/0]
via 3FFE:501:FFFF:100:200:FF:FE00:A1A1, Vlan 6
via FE80::200:FF:FE00:A1A1, Vlan 6
Table 18‐2describestheoutputoftheshowipv6routecommand.
protocol Specifiesthe protocolthatinstalledtheroutes.Protocolcanbeoneofthe
followingkeywords:
connected
static
ospf
all SpecifiesthatallIPv6routesshouldbedisplayed,includingbestand
non‐bestroutes.Otherwise,onlythebestroutesaredisplayed.
Note: If you specify the connected keyword, the all option is not available
because there will be no best or non-best routes.
Table 18-2 Output of the show ipv6 route Command
Output... What it displays...
Codes: Displays the key for the routing protocol codes that might appear
in the Codes column of the routing table output.
Codes column The code for the routing protocol that created this routing entry.