Specifications

show ipv6 route
SecureStack C3 Configuration Guide 18-25
Vlan 6
FE80::2D0:B7FF:FE2C:769E 00:d0:b7:2c:76:9e False Stale 1461
Vlan 6
FE80::2D0:B7FF:FE2C:76AA 00:d0:b7:2c:76:aa False Stale 1540
Vlan 6
FE80::2D0:B7FF:FE2C:76AB 00:d0:b7:2c:76:ab False Stale 1553
Vlan 6
FE80::2D0:B7FF:FE2C:76AC 00:d0:b7:2c:76:ac False Stale 1566
Vlan 6
FE80::2D0:B7FF:FE2C:76B4 00:d0:b7:2c:76:b4 False Delay 1903
Vlan 6
show ipv6 route
ThiscommanddisplaystheIPv6routingtable.
Syntax
show ipv6 route [{ipv6-addr [protocol] | {{ipv6-prefix/prefix-length | interface}
[protocol] | protocol | summary} [all] | all} ]
Parameters
Table 18-1 Output of show ipv6 neighbor Command
Output field... What it displays...
IPv6 Address The IPv6 address of the neighbor on the interface.
Interface The interface on which this neighbor was discovered.
MAC Address The link layer address of the neighbor.
isRtr Shows whether the neighbor is a router. If the value is True, the
neighbor is known to be a router. Otherwise, the value is False.
Neighbor State State of the cache entry. Possible values are Incomplete,
Reachable, Stale, Delay, Probe, and Unknown.
Last Updated Shows the system uptime when the information for the neighbor
was last updated.
ipv6‐addr SpecifiesaspecificIPv6addressforwhichthebest‐matchingroute
shoudbedisplayed.
ipv6‐prefix/prefix‐length The IPv6networkprefixoftheroutetodisplay,andtheprefixlength.
TheprefixmustbeintheformdocumentedinRFC4291,withthe
addressspecifiedinhexadecimalusing16‐bit
valuesbetweencolons.
Theprefixlengthisadecimalnumberindicatingthenumberofhigh‐
ordercontiguousbitsoftheaddressthatcomprisethenetworkportion
oftheaddress.
interface Specifiesthattherouteswithnext‐hopsonthisinterfaceshouldbe
displayed.Interfacecanbeoftheform:
vlanvlan‐id
tunnel
tunnel‐id
loopbackloop‐id