Specifications

ipv6 nd other-config-flag
18-18 IPv6 Configuration
ipv6 nd other-config-flag
Thiscommandsetsthe“otherstatefulconfiguration”flaginrouteradvertisementssentonthis
interfacetotrue.
Syntax
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Parameters
None.
Defaults
Flagissettofalsebydefault.
Mode
Routerinterfaceconfiguration:C3(su)‐>router(configif(Vlan1))#
Usage
Whenthevalueofthe“otherstatefulconfigura tion”flagistrue,endnodesshouldusestateful
autoconfiguration(DHCPv6)toobtainadditionalinformation(excludingaddresses).Whenthe
valueisfalse,endnodesdonot.RefertoRFC2462,“IPv6StatelessAddressAutoconfiguration,”
formoreinformation.
Usethenoformofthiscommand
toresettheflagtofalse.
Example
Thisexamplesetstheotherstatefulconfigurat ionflagtotrue.
C3(su)->router(configif(Vlan 1))# ipv6 nd managed-config-flag
ipv6 nd ra-interval
Thiscommandsetsthetransmissionintervalbetweenrouteradvertisements.
Syntax
ipv6 nd ra-interval sec
no ipv6 nd ra-interval
Parameters
Defaults
600seconds.
Mode
Routerinterfaceconfiguration:C3(su)‐>router(configif(Vlan1))#
sec Specifiesthevalueinsecondsoftherouteradvertisementtransmission
interval.Thevaluecanrangefrom4to1800 seconds.