Specifications

enable
16-52 IPv4 Routing Protocol Configuration
enable
UsethiscommandtoenableVRRPonaninterface.ThenoformofthiscommanddisablesVRRP
onaninterface.
Syntax
enable vlan vlan-id vrid
no enable vlan vlan-id vrid
Parameters
Defaults
None.
Mode
Routerconfiguration:C3(su)‐>router(Config‐router)#
Example
ThisexampleshowshowtoenableVRRPontheVLAN1interface,VRID1:
C3(su)->router(Config)#router vrrp
C3(su)->router(Config-router)#enable vlan 1 1
vlanvlan‐id Specifies thenum berofthe VLANonwhichtoenableVRRP.ThisVLAN
mustbeconfiguredforIProutingasdescribedin“Pre‐Routing
ConfigurationTasks”onpage14‐1.
vrid SpecifiestheVirtualRouterID(VRID)associatedwiththevlan ‐id.Valid
valuesarefrom1to255
.